Pneumatic controls piFLOW®f

Piab control units are fully pneumatic operated with an extremely reliable function. The full pneumatic design also removes any source of ignition from the system and at the same time simplifies the validation process.

Control Unit PPT/RS

Controls the functions of the conveyor. Fully pneumatic. The maximum recommended distance between the conveyor and control unit is 10 metres when feed pressure is 0.6 MPa. Setting time can...

Control unit CU-1A/B, CU-2A/B

Controls the functions of the conveyor Fully pneumatic The maximum recommended distance between the conveyor and control unit is 10 metres when feed pressure is 0.6 MPa Function of the...

Maintenance kit piFLOW® pumps

Used for start-up and maintenance of a Piab conveying system Complete kit, ready to use 4x10 m Nylon tubing D=4/2 included Enables reading of vacuum and pressure levels Actuating valve...

Capacitive sensor

Use together with valve unit for level detector (0124051). Stops the conveyor when level in receiving vessel is reached.

Valve unit for level detector CU-1/2

Apply with CU-1/2. Level sensor must be ordered separately. Note: When the level sensor is activated (leakage in port 8 at CU-unit), the bottom lid will close regardless of the...

Capacitive sensor ATEX

Use together with valve unit for level detector (0124051). In compliance with ATEX. Stops the conveyor when level in receiving vessel is reached.

Valve Unit VU EP-1

Valve unit with electro-pneumatic valves that can be used to control Piab’s vacuum conveyors with external PLC or similar electrical control system. Simple installation: Prepared for connection to the vacuum...

Regulator kit piFLOW®i/f

Regulates the incoming pressure to the pump. The filter cleans the compressed air.

Remote-controlled start/stop

Remote-controlled start and stop of the conveyor. Fully pneumatic. Visual signal (pneumatic eye) shows if the conveyor is running. Use together with CU-1A/B or CU-2A/B.